Avoid These Common Glass Shower Door Installation Mistakes

Installing a glass shower door is a great way to add style and elegance to your bathroom. But if you don’t take the time to do it right, you could end up with a costly mistake that can be difficult to fix. Here are some common mistakes to avoid when installing a glass shower door.

Not Measuring Properly

One of the most important steps in installing a glass shower door is measuring properly. You need to make sure that the door will fit correctly in the opening and that there is enough room for it to open and close without hitting anything. If you don’t measure correctly, you could end up with an ill-fitting door that won’t work properly. Take your time and measure twice before cutting or drilling any holes.

Another mistake people make when measuring for their glass shower door is not taking into account the thickness of the glass. Most glass doors are 3/8″ thick, so you need to make sure that your measurements account for this extra thickness. Otherwise, you could end up with a door that doesn’t fit properly.

Finally, make sure that you measure from the outside edges of the frame, not from the inside edges. This will ensure that your measurements are accurate and that your door will fit correctly.

Not Using the Right Hardware

When installing a glass shower door, it’s important to use the right hardware for the job. Make sure that all of the screws, hinges, and other hardware are rated for use with glass doors. Using hardware that isn’t rated for glass can cause damage to the door or even cause it to break.

It’s also important to make sure that all of the hardware is installed correctly. Make sure that all of the screws are tightened securely and that all of the hinges are aligned properly. If any of these steps are done incorrectly, it could lead to problems with your door down the line.

Finally, make sure that you use silicone sealant around all of the edges of your glass shower door. This will help keep water from seeping through and causing damage.

Not Leveling Properly

When installing a glass shower door, it’s important to make sure that it is level and plumb. If it isn’t level or plumb, then it won’t open or close properly and could cause damage over time. To ensure that your door is level and plumb, use a level when installing it and adjust as needed until it is perfect.

Another mistake people make when installing their glass shower doors is not checking for squareness. The frame should be perfectly square so that the door fits snugly in place without any gaps or overlaps. Use a carpenter’s square to check for squareness before securing the frame in place.

Finally, make sure that you check for levelness after installation as well. Even if everything looks good during installation, things can shift over time due to normal wear and tear or changes in temperature or humidity levels.

Not Cleaning Properly

Before installing your glass shower door, it’s important to clean both sides of the glass thoroughly with soap and water or a mild cleaner like Windex®. This will help remove any dirt or debris from the surface which can interfere with proper installation and cause damage over time.

Once you’ve cleaned both sides of the glass, make sure you dry them completely before installation begins. Any moisture left on either side can cause problems with adhesion or cause streaks on your finished product.

Finally, once your glass shower door has been installed, make sure you clean it regularly with soap and water or a mild cleaner like Windex® to keep it looking its best.

Conclusion

Installing a glass shower door can be tricky but following these tips can help ensure success! Make sure you measure properly, use only hardware rated for use with glass doors, check for levelness and squareness during installation, and clean both sides of the glass before installation begins. Doing these things will help ensure that your new glass shower door looks great and lasts for years!

• • Measure twice before cutting or drilling any holes
  • Use only hardware rated for use with glass doors
  • Check for levelness & squareness during installation
  • Clean both sides of the glass before installation begins